Near-ready-to-fly semi-realistic model (1500 mm wingspan) of a Swiss STOL utility aircraft. Made of carbon-reinforced expanded polyolefin (EPO); KAVAN C3548-750 brushless motor, 10x6" three-blade propeller, R-40SB ESC and 6 micro-servos installed. Full house" aileron, flap, elevator, rudder and throttle control; steerable water rudder/tail wheel, LED lights. For 4S LiPo 2600-3300mAh battery (at least 30C).
The fully carbon-reinforced EPO foam fuselage comes with the KAVAN C3548-750 brushless motor, a 10x6" three-blade propeller and a KAVAN R-40SB ESC with a powerful SBEC switchable stabilizer needed to power the 6 servos on board. The battery compartment (under a removable hatch in the nose) offers plenty of space for your flight pack.
The two-piece EPO wing is reinforced with carbon spars and assembled with carbon tubing. The wing is bolted to the fuselage. Ailerons and flaps are controlled by two pairs of servos installed in the wing and driven by short-wire pushrods; LED position and landing lights are also installed. Easy-to-install carbon struts are attached with a pair of metal clips.
The tailplane is made of EPO foam. The elevator servo is installed in the fuselage, the rudder servo in the aileron.
Floats are optional below.
EPO fuselage with brushless motor, 40A ESC, 10x6" three-blade propeller with 2 servos installed, EPO wing with 4 servos and LED lights installed, EPO horizontal tail, landing gear and instruction manual.
Optional floats available (see photo).
